Pantac Molle Forward Deployment Pack


Pre-order will take 9-14 days, shipping time is not included

USD 166.99

Add to wishlist

More info

Product Feature:
- Removable thick padded belt
- Mesh padded straps for ventilation
- Allows up to 3 L reservoir (not included) inside, hytration tube port on top of backpack
- MOLLE panel inside main compartment for attaching optional MOLLE pouches
- Long open top pouches on both sides on holding long size items like camera tripod etc.
- Velcro area on upper front for attaching patches
- MOLLE PALS on front and both sides for optional pouches
Main Compartment: Approx. 33W x 50H x 19D cm
Upper front pocket: 6W x 33H x 5D cm
Upper front flat pocket on top: 6W x 33H cm
Lower front pocket: 6W x 0H 7D cm

All products are order to make, it takes 7-14 days for shipping out?

Special Feature of Pantac products :
- Heavy-duty, abrasion and water resistant 1000 denier INVISTA Cordura Ballistic Nylon Fabric exterior construction.
- # Crye Precisoin heaviest MULTICAM 500/1000 Denier CORDURA fabric used for all Pantac Multicam Camoflage products.

#Multicam Fabric SPES:
Finished Width - 60 inches cuttable
Finished Weight - 9.8 oz/yd approximately
Fiber Content - 100% nylon
Construction - 35/30 (warp/fill)
Breaking Strength - 593/580 (warp/fill) (lbs, minimum

- Highest quality and best selection of YKK zippers for Pantac Products
- Military specification nylon webbing
- ITW Nexus and UTX buckles are adopted to comply military specification
- Heavy duty mil. spec. sewing seam, 6 plied nylon yarn


No customer comments for the moment.

Write a review

Pantac Molle Forward Deployment Pack

Pantac Molle Forward Deployment Pack

Write a review

Customers who bought this product also bought:

30 other products in the same category: